网站转让 → 您的公司名称

控制柜工艺特点介绍
Introduction to the Process Characteristics of Control Cabinet
1、柜门离地25mm、2.5mm厚的安装板，两边有20mm宽的U形弯边，使得安装板强度更大，也便于搬运。
1. Installation plate 25mm and 2.5mm thick from the ground of cabinet door, with 20 mm wide U-shaped bends on both sides, makes the installation plate stronger and easier to carry.
2、箱底三块电缆导入盖板，可以相互替换，移动方便，易于导入电缆，易于开孔进线。
2. The three cables at the bottom of the box can be replaced by each other. They are easy to move and lead into the cables. They are easy to open and enter the cables.
3、箱门上有接地螺栓5、承重铰链安装容易，换柜门也容易。柜门可开启130°。
3. There are grounding bolts on the box door 5. It is easy to install the load-bearing hinge and change the cabinet door. The cabinet door can be opened 130 degrees.
4、塑料滑引器可利用塑料滑引器通过导轨，可从柜体正面将安装板推入柜内7、坚固的长方形框架不但可以加强前门的强度，还可以用来固定安装电器元件（配合门安装横条使用）。
4. Plastic slider can use plastic slider to pass through the guide rail. It can push the installation board into the cabinet from the front of the cabinet. 7. The solid rectangular frame can not only strengthen the strength of the front door, but also be used to fix and install electrical components (with the installation bar of the door).
5、背板能很容易地安装，用螺丝固定；还可换装柜门。
5. The backplane can be easily installed and screwed, and the cabinet door can be replaced.