网站转让 → 您的公司名称

结构篇 Structure text 编辑 edit PS框架式通用控制柜工艺特点介绍 Introduction of process characteristics of PS frame type general control cabinet 控制柜 control cabinet 控制柜 control cabinet 1、柜门离地25mm、2.5mm厚的安装板，两边有20mm宽的U形弯边，使得安装板强度更大，也便于搬运。 1, the door to the ground 25mm, 2.5mm thick installation board, both sides have 20mm wide U shaped curved edge, making the installation plate greater strength and easy to carry. 2、箱底三块电缆导入盖板，可以相互替换，移动方便，易于导入电缆，易于开孔进线。 2, the bottom three cable entrance cover plate, can be interchanged, easy to move, easy to guide cable, easy to open hole into the line. 3、箱门上有接地螺栓5、承重铰链安装容易，换柜门也容易。柜门可开启130°。 3. There are earthing bolts on the door of the box 5, the load hinge is easy to install, and it is easy to change the door of the cabinet. The cabinet door can be opened 130 degrees. 4、塑料滑引器可利用塑料滑引器通过导轨，可从柜体正面将安装板推入柜内7、坚固的长方形框架不但可以加强前门的强度，还可以用来固定安装电器元件（配合门安装横条使用）。 4, plastic slip inducer using plastic slip inducer by rail, from the front side of the cabinet will be installed in the cabinet plate into a rectangular frame 7, the firm can not only strengthen the strength of front door, can also be used for fixed installation of electric components (with the use of horizontal door installation). 5、背板能很容易地安装，用螺丝固定；还可换装柜门。 5, the backboard can be easily installed, screw fixed, and can also be converted to the door. 6、标配MS821锁，上、中、下三点锁紧柜门。 6, mark the MS821 lock, lock the door at three points on the top, the middle and the lower. 7、密封圈：聚氨脂发泡密封胶条，确保防护等级。 7, sealing ring: polyurethane foam sealant bar, to ensure the protection level. 8、柜门框处增加防水边与柜门密封圈配合防止水和灰尘落入柜内。 8. Add waterproof edge and door sealing ring at the door frame to prevent water and dust falling into the cabinet. 9、（单门）左右互换开门设计，方便使用 。标准模数化安装孔设计，方便安装。 9, (single) swap around door, easy to use. Standard modular installation hole design, easy to install. 10、内灯，方便安装和检测（自选件）。 10, inner lamp, convenient installation and inspection (self selection).